Views: 0 Author: Site Editor Publish Time: 2021-11-11 Origin: Site
I heard this process
9 of 10 laser cuts are posted
Laser cutting machine safe operation specification process
1. Comply with the general safety operation regulations of fiber laser cutting machine. Strictly follow the laser start procedure to start the laser, adjust the light, and test the machine:
2. The operator must be trained, familiar with cutting software, equipment structure, performance, and master system related knowledge
3. Wear labor protection equipment as required, and must wear laser protective glasses that meet the requirements near the laser beam;
4. Before clarifying whether a certain material can be irradiated or cut by laser, do not process it to avoid the potential danger of smoke and steam;
5. After turning on the machine, the machine tool should be manually started in the X and Y axis directions at low speed, and check to confirm whether there are any abnormalities:
6. After inputting the new part program, test run it first, and check its operation:
7. When the equipment is started, the operator shall not leave the post or be taken care of without authorization. If it is necessary to leave, the operator should stop the machine or cut off the power switch;
8. Keep the fire extinguisher within easy reach; turn off the laser or shutter when not processing; do not place paper, cloth or other flammable materials near the unprotected laser beam;
9. When an abnormality is found during the processing, the machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor in time;
10. Keep the laser, laser head, bed and the surrounding area clean, orderly, free of oil, and stacking workpieces, plates, and waste materials according to regulations;
11. When using gas cylinders, avoid crushing the welding wires to avoid leakage accidents. The use of gas cylinders should comply with the gas cylinder supervision regulations. When the gas cylinder is exposed to the sun or close to a heat source to open the bottle valve, the operator must stand on the side of the bottle mouth;
12. The high-pressure safety regulations should be followed during maintenance, and the maintenance should be carried out in accordance with the regulations and procedures every 1 day or every week of operation, and every 1000 hours of operation or every 6 months.