close
Choose Your Site
Global
| Quantity: | |
|---|---|
SL-5W
SIEME
Product Description
Laser (light source): 355 nm UV laser
Air-cooled device, small size, 20,000 hours maintenance-free (theoretical 20,000 hours of service life).
It requires water cooling, distilled water or pure water.
The focused spot is extremely small, and the processing heat affected zone is small (cold light), making the material heat-receiving area smaller. Not susceptible to heat deformation, ultra-fine marking, special material marking.
Low cost of use, better beam quality, high efficiency, low power consumption, more energy saving and environmental protection.
Can be applied to high-end market, ultra-fine marking environment, cosmetics, pharmaceuticals, LCD liquid crystal, electronic components, communication equipment, food and medicine packaging, glass division, electronic components, metal jewelry marking.
UV Laser Marking Machine | |||
Parameter | Unit | Description | |
Wavelength | 354.7 | nm | |
Average Output Power | 2.0~~10.0 | W | @30kHz |
Pulse Width | <16 | ns | @30kHz |
Pulse Repetition Rate | 10-100 | kHz | |
Spatial Mode | TEMoo | ||
M2 | <1.2 | ||
Beam Diameter | 2.0+/-0.2 | mm | 1m Measured at window |
Beam Full Divergence Angle | <0.5 | mrad | |
Beam Circularity | >0.9 | ||
Pulse-to-Pulse Stability | <3 | % | RMS |
Average Power Stability | <5 | % | RMS/8hr |
Beam-Pointing Drift | <25 | µrad/℃ | |
Polarization Ratio | >100:1 | ||
Polarization Orientation | Horizontal | ||
Operating Temp. & RH | 10 to 35 | ℃ | |
Storage Temp. & RH | -20 to 65 | ℃ | |
Electricity Requirement Power Consumption | 100-240 | VAC | Single phase |
Warranty | 12 | months | |
UV laser marking machine widely used in 3C industry marking, as well as industrial micro machining, including marking for a diversity of materials, plastic,glass, LED scribing, laser rapid prototyping, removal of metal and non-metal coating, silicon wafer processing and so on.
